Skip to Content

Wood Carving How to Select the Right Methods

August 29, 2017 • omweb

Following seeing a couple of posts and courses on making digging blades, I wanted to give it a try. Many instructional data that I have found, facts making your own knife from creating the knife all the way to making the handle. I do not obviously have all the proper resources or experience to make my own personal knives, then when I found some a few ideas employing a blade from an old pocket knife, I got at the chance to take to it. It turned out pretty good, so I desired to give the data to my visitors.
Image result for wood carving pocket knife
The first faltering step is to find the old blade that you want to make use of a blade from best knives for whittling. Following eliminating the knife from the wallet knife, find your ideal type of wood for the manage and cut out a 3/4″ by 3/4″ by 5″ piece (I’m using hickory) and then split that in half.

Now outline the location of the edge that’ll be recessed in the handle and eliminate a notch so that the knife rests only remove with this half the handle. Now using a punch, punch an opening through equally halves where the green goes to put up the edge in position and then drill another hole through both halves closer to the other conclusion of the handle. I used a few nails for the hooks in this project.

Now after making a dry run putting the two halves together with the nails and blade in position, you’re ready to utilize some JB Weld or 5 Second Epoxy within the recess for the edge and then rapidly place the edge in. Now apply more bonding element to another side of the knife break and along both halves of wood. Place both halves together and insert the nails. Employing a clamp, hold the blade together to guarantee a limited match for drying. You may have to wipe away a number of the surplus bonding compound that squeezes out.

Allow the clamped blade to dry for at least twenty four hours and then remove the clamps. Work with a cutoff wheel or hacksaw to take off the claws flush with the wooden manage and use a sander to sand the blade smooth. I applied a power give sander to circular off the sides and easy off the take off nails.

So you have a digging knife that you may be happy that you made. You might want to utilize a woodburner and burn your initials into the handle and/or use yet another knife and carve a structure in the handle. You can now keep the handle normal or use your favorite finish to seal the handle.

Leave a Reply

Your email address will not be published.